While many schools, workplaces, and even homes have tracked down a need to make bound records, not every person has the financial plan or the space for a full-capability restricting machine. For those that need to have the option to at times tie their own records, the GBC VeloBind V50 is a reasonable, section level restricting machine that is sufficiently little to fit on a work area while as yet being adequately strong to punch up to 20 sheets for each lift. The following is an outline of restricting records with the GBC VeloBind V50:

Start by adjusting the mim 316 of your archive by tapping them more than once against your work surface.

Embed up to 20 sheets into the punching throat. Assuming that your record is longer than 20 pages, you should embed the sheets in sets. Note: The greatest punching limit of the V50 is 20 sheets (in light of ordinary 20 lb. paper; on the off chance that you are utilizing cover stock or thicker paper, your punching limit will be decreased).

Push the punching switch with two hands to punch your report with the 4-pin VeloBind design.

Eliminate the sheets from the punching throat, and rehash the cycle as vital until your whole record has been punched.

Place the report onto your work table so it is looking up and the openings loom over the table’s edge.

Embed the pins on the VeloBind spine descending through the poked holes.

Cautiously turn the archive over and lay it level on the table, guaranteeing that the spine stays set up.

Place the opened strip over the four pins, with the spaces looking up.

Secure the strip by holding it in the middle and adjust the pins properly, utilizing your thumb and pointer. When each of the four pins have been fit properly, the tight spot is finished.

Since the VeloBind 4-pin strips that are utilized with the GBC VeloBind V50 are recloseable, reports bound with them can undoubtedly be debound and altered. The following is an outline of how to debind reclosable 4-pin VeloBind strips:

Note: GBC produces an instrument that is explicitly intended to debind 4-pin VeloBind strips. The directions underneath show debinding methods that don’t need the utilization of a debinding instrument. In the event that you anticipate doing a high volume of debinding, you will find that a debinding device is significantly more proficient.

Utilize the tip of a pen to slide over the mark of the pin and use influence to pry the pin out of position.

Keep pulling the trigger up until it is gotten back to its upstanding position.

Rehash with every one of the excess pins and eliminate the opened strip.

Punch all substitution sheets and supplement them into your report as wanted (or basically eliminate any undesirable pages).

Follow the means recorded above for embedding the spine into your archive and snapping the pins shut.